You've unwrapped your new piece, found the perfect spot on the wall, and now it's time to actually hang the thing. Whether you've gone glass or ceramic, installation is designed to be simple and stress-free.

Installing glass pieces

You’ll need a Phillips screwdriver & wall plug.

Step One: Ensuring the wall plug is completely straight, use a hammer to knock the tip into the gib where you'd like to position your new glass piece. Please note if you’re installing the piece straight into wood you don’t need to use the wall plug and can skip to step 3.

Step Two: Use a screwdriver to screw the wall plug into the wall. Once you're done, the flat circular top of the plug should sit completely flush with the wall.

Step Three: Screw your glass piece directly into the wall plug & you're all done.

Installing ceramic pieces

You’ll need brass angled nails & a hammer. 

Step One: Position brass nail on the wall with the sharp tip pointing down at a 45° angle.

Step Two: Hammer nail all the way in so the brass disc sits flush against the wall. The nail will work in gib or a stud; made for use in any type of wall except concrete.

Step Three: Hang the Candyman or Milk Bottle using the hole at the back. You're all done! 

Planning a Big Spill?

A little planning goes a long way. Measure your wall space first, then jump onto our Big Spill tool to map out your arrangement before you touch a drill or hammer. When your Big Spill arrives, jump in and follow our Big Spill installation guide.

For piece-specific detail, our full installation guides have you covered.